Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterOlympia Chimney Chimney Repair in Long Island: What to Know First
Olympia Chimney repair in Long Island is work we do regularly, and most jobs wrap up in a single visit. You’re looking at honest pricing for the actual condition of your flue. Nothing more, nothing less. If you’ve got an Olympia chimney that’s spalling brick, leaking at the flashing, or showing mortar joints that have turned to sand, call (516) 968-5380 and Wendell or one of the crew will give you a straight answer before a single tool comes off the truck.
This page is for Long Island homeowners with Olympia Chimney products who want to know what’s wrong, what it costs, and whether it even needs fixing. We’ve been at this since 1999, and we’ll tell you plainly when a chimney can wait and when it can’t.
How Olympia Chimney Products Fail and How We Fix Them
Olympia Chimney builds solid products, but every chimney on Long Island eventually meets the same enemies: salt air, freeze-thaw cycles, and years of heat. Here’s what we actually see on Olympia units out here:
- Mortar joint erosion on Olympia masonry chimneys. The older Olympia masonry systems we see in Levittown and Wantagh ranch houses tend to lose mortar before anything else goes. Long Island winters push water into hairline cracks, it freezes, it expands, and the joint crumbles. We grind out the failed mortar and repoint with a mix matched to your existing brick’s hardness. Caught early, this is a one-day fix. Left alone, it becomes a rebuild.
- Spalling brick faces from trapped moisture. On Olympia chimneys that were never waterproofed, brick faces start popping off in sheets. What you’re seeing is water that got in and couldn’t get out. We remove the damaged brick, replace what’s needed, and apply a breathable waterproofing treatment made for masonry chimneys in coastal climates like ours.
- Cracked crown on Olympia pre-fab and masonry terminations. The crown takes the worst of Long Island weather, and when it cracks, water finds its way straight down into the chimney structure. We build crowns with a proper overhang and a flexible bond break so the next freeze-thaw cycle doesn’t crack it again within two seasons.
- Flashing separation where the roof meets the chimney. Several Olympia chimney failures we fix out near the North Shore start at the roofline, not the chimney. Flashing loosens as the house settles and ice works underneath it. We remove the old flashing, inspect the surrounding roof deck for rot, and install new step and counter flashing that’s sealed and fastened to last through real Long Island winters.
- Damper and smoke shelf deterioration inside Olympia fireplaces. What owners often describe as a “smoky fireplace” is usually a damper that no longer seats right or creosote layered thick on the smoke shelf. The chimney isn’t drawing because air can’t move the way it should. We clean the smoke shelf, repair or replace the damper, and test the draft before we call the job done. If it doesn’t need a new damper, we’ll tell you that, too.
Our Olympia Chimney Chimney Repair Process
Here’s how a repair goes when you call us about your Olympia chimney:
- 1
You call, a person answers. It might be Wendell. You describe what’s happening, and we ask a few questions: When did you notice it? Any water stains? Does the fire draw like it used to? We’ll give you a straight read on whether it sounds urgent.
- 2
We come out and look hard. The sweep who shows up at your door is background-checked, in uniform, and carrying a camera. Not just any camera. The kind that goes down the flue so you can see what’s happening inside your chimney with your own eyes.
- 3
You get the camera footage and a plain-English verdict. This is where our customers tell us they finally understood their chimney. If it’s a brush job, we say so. If it needs a new liner, we show you why. No mystery, no pressure.
- 4
We quote a number before work starts. The number you hear is the number on the invoice. For an Olympia chimney repair, we’ll talk through whether OEM parts make sense or whether a quality aftermarket equivalent does the same job without the price tag. If a competing written estimate says more, bring it in for a free second opinion.
- 5
The repair happens, then the test. Mortar gets repointed, flashing gets replaced, brick gets rebuilt. Then we test the draft and verify the fix holds. You’ll see the before-and-after on camera.
- 6
You get the 90-Day Done Right Promise in writing. If it’s not right, one call brings the crew back at no additional cost. That’s stamped on every single job.
What Olympia Chimney Chimney Repair Costs in Long Island
Here’s the honest picture of what we charge for common Olympia chimney repairs in our area. Every job gets an exact quote before work begins, and remember: $40 off any repair over $200, and no trip charge if you’re inside our service county.
- Mortar repointing (small to medium area): $350 to $850
- Brick replacement and spalling repair: $600 to $1,500 depending on how many bricks and access difficulty
- Chimney crown rebuild: $400 to $950
- Flashing repair or replacement: $450 to $1,200
- Chimney waterproofing: $300 to $700
- Partial chimney rebuild (from roofline up): $1,800 to $4,500
What moves the price is access, how much brick has failed, and whether we uncover rot underneath. That’s why we don’t quote over the phone. Call (516) 968-5380 and we’ll inspect, show you the camera footage, and give you the real number.
Why Long Island Homeowners Call Top Hat Chimney for Olympia Chimney Work
Long Island has a lot of chimney companies, and a fair number of national chains that send a stranger with a clipboard and a quota. Wendell Pike has been working chimneys here since 1999, and his name is on the work. When you call, a live person answers, around the clock. The sweep who shows up knows Olympia Chimney systems, but also knows DuraFlex, HeatShield, and Gelco, so you get a straight recommendation that fits your house, not whatever’s on the truck that day. And every job is backed by the 90-Day Done Right Promise in writing. Ask anyone on your street. Chances are good they already have our number.
FAQs
In most cases, no. As an independent Olympia Chimney service provider, we perform repairs that preserve your warranty rather than void it. The key is using the right materials and methods for the specific Olympia product, and we do that every day. If there’s any question about warranty coverage on your particular model, we’ll tell you before we touch anything.
Yes. Many Olympia Chimney components are still available through our trusted supply channels, and when a part is back-ordered or discontinued, we’ll show you a quality equivalent from brands like DuraFlex or HeatShield that does the same job without compromising safety or longevity. Our goal is a working chimney, not a parts invoice.
That’s exactly what the camera inspection answers. If you’re seeing water stains on the ceiling, crumbling mortar, brick faces falling onto the lawn, or smoke pouring into the room when the fire is lit, you’re likely looking at a repair. If the fire draws fine and you just haven’t had it swept in a few years, you probably need a cleaning. We’ll tell you which it is. If it doesn’t need fixing, we’ll tell you that first.
Most repairs, from a crown rebuild to flashing replacement, finish in a single day. Partial rebuilds and extensive brick work can take two to three days depending on weather and access. We’ll give you a clear timeline before we schedule anything, and if the job runs long because of something we find, we’ll call you before we do anything extra.
Once a year, burn or no burn. Chimneys break in the off-season, too. Freeze-thaw cycles, salt air, and nesting animals don’t care whether you’re using the fireplace. An annual inspection catches mortar erosion and crown cracks before they become rebuilds. If you haven’t had yours looked at this year, call (516) 968-5380 and we’ll get you on the schedule.
Written by Wendell Pike, Owner, Top Hat Chimney at Top Hat Chimney, serving Long Island and nearby areas.